
Introduction
PLA filament that snaps after humid storage and sheet that cracks during thermoforming may both be described as brittle. The timing of failure is the useful clue. Compare material immediately after extrusion with samples conditioned for the expected storage and use period.
Why fresh and aged PLA can behave differently
PLA contains ester bonds in its backbone. Moisture can cause chain scission during melt processing and later during service. Lower molecular weight can reduce ductility, while crystallinity and thermal history also affect stiffness and fracture behavior. Compare specimens with the same geometry and processing history before assigning the change to chemical degradation.
Figure 1. PLA hydrolysis and carbodiimide stabilization
1. Ester-bond cleavage
P–C(=O)–O–CH(CH₃)–P + H₂O → P–COOH + HO–CH(CH₃)–P
2. Capture of the carboxyl end group
P–COOH + R¹–N=C=N–R² → O-acylisourea intermediate → N-acylurea adduct
Choose the test around the product
For filament, track extrusion consistency, diameter and bend-to-break behavior after storage. For thermoformed sheet, record forming stability and inspect corners and sidewalls for cracking. For molded items, compare impact or elongation after conditioning. Include packaging or moisture-barrier conditions when storage is part of the customer requirement.
A practical selection guide
| Observed problem | What to check | What to evaluate first |
|---|---|---|
| Fresh filament is brittle | Compare feed moisture and fresh melt flow at fixed test conditions. | Correct drying and melt history |
| Fresh parts pass but crack after humid storage | Compare aged bend or impact performance and use matched controls. | HyMax® stabilization |
| Dry resin still has weak melt strength during forming | Compare sag, die pressure and gels. | Discuss a KL-180 chain-extension trial |
How to qualify HyMax® and KL-180
Ask for a HyMax® grade matched to the PLA grade, melt temperature and appearance requirements. Where compostability is required, evaluate the final article, including additives, thickness and intended certification route.
Run a dried, additive-free control and a HyMax®-only formulation at supplier-recommended levels. Add a KL-180-only trial where a defined melt-processing issue warrants it. Record resin and additive lots, active content or let-down, drying and processing history. Compare both initial and aged results against a predefined acceptance threshold before deciding whether to try a combination.
Frequently asked questions
Will a stabilizer preserve a compostability claim?
The claim depends on testing and certification of the finished formulation and article under the relevant conditions. Storage durability and end-of-life performance need separate evaluation.
Can a hydrolysis stabilizer replace resin drying?
Follow the resin supplier’s drying guidance and record moisture at the feed point. An additive trial is easier to interpret when every formulation starts from a comparable moisture history.
Discuss your application with Langyi
Share your resin grade, processing route, target properties and ageing conditions when contacting Hong Kong Langyi. See related applications in Polymers, Films & Coatings.