Industry Insights

Explore the latest trends, technical innovations, and market intelligence in functional materials and global chemical supply chains.

Browse by Category

Need a Custom Quote?

Connect with our team for tailored sourcing solutions.

All Posts

Polyester TPU Films and Coatings: Diagnosing Hydrolysis After Humid Exposure

Introduction A coated textile can pass peel testing before shipment and delaminate after warm, humid storage. A TPU film may become tacky or tear sooner after a similar exposure. The first step is to locate the failure within the film, coating, adhesive or substrate. This guide focuses on diagnosing the finished construction and qualifying a formulation against that failure. Where hydrolysis occurs in polyester TPU The representative bond in the diagram lies in the polyester soft segment. Water-driven ester cleavage creates carboxyl and hydroxyl ends and can undermine mechanical retention. Confirm the soft-segment chemistry with the resin supplier. Check for

Read More »
All Posts

PBAT and PLA/PBAT Film Hydrolysis: A Guide for Blown-Film Converters

Introduction A blown-film converter may face an unstable bubble during production or bags that tear more easily after warehouse storage. Separate the two problems before adjusting the additive package. Record line behavior and test fresh film before comparing aged rolls. How the PBAT backbone changes in humid conditions PBAT contains butylene adipate and butylene terephthalate units. Both provide ester linkages susceptible to hydrolysis. The diagram shows one representative ester at a butylene segment. In a PLA/PBAT blend, both resins can contribute to changes in molecular weight, while blend morphology and filler dispersion can also affect tear and elongation. Figure 1.

Read More »
All Posts

PLA Hydrolysis: Preventing Brittle Filament, Sheet and Molded Parts

Introduction PLA filament that snaps after humid storage and sheet that cracks during thermoforming may both be described as brittle. The timing of failure is the useful clue. Compare material immediately after extrusion with samples conditioned for the expected storage and use period. Why fresh and aged PLA can behave differently PLA contains ester bonds in its backbone. Moisture can cause chain scission during melt processing and later during service. Lower molecular weight can reduce ductility, while crystallinity and thermal history also affect stiffness and fracture behavior. Compare specimens with the same geometry and processing history before assigning the change

Read More »
All Posts

PET Hydrolysis in Film Extrusion and Humid Service: What to Measure and How to Stabilize It

Introduction A PET film line can lose intrinsic viscosity (IV) in a single extrusion pass. A different film may leave the line within specification and split only after warm, humid storage. These failures call for different corrective actions. Sampling the resin at the feed throat, the film at release and the same film after ageing shows where the loss starts. What a drop in IV tells you Water cleaves the ester linkage between a terephthalate-derived carbonyl and the ethylene glycol-derived segment. The resulting shorter chains typically lower IV. Compare IV alongside feed moisture and processing history. Excessive thermal exposure can

Read More »